Search:

Type: Posts; User: Lefty

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    1,027

    Wasnt available when I bought my BT380 but if it...

    Wasnt available when I bought my BT380 but if it was would of purchase it sounds as reliable as my 380 and BT40HC and BT9HC and ACAmigo and owell you get my drift WELCOME TO THE FORUM johnnyflake!!!
  2. Thread: blueing

    by Lefty
    Replies
    4
    Views
    751

    viper125 it could be alot of things contributing...

    viper125 it could be alot of things contributing to premature wear your holster probably the biggest culprit being leather a tight fit in humid weather or just could be a bad matte finish to start...
  3. Thread: BP CC 9mm

    by Lefty
    Replies
    37
    Views
    6,778

    Thanks Bersa Sales Im sure theyll go quick

    Thanks Bersa Sales Im sure theyll go quick
  4. Replies
    1
    Views
    794

    Welcome to the Forum sog481v I believe only...

    Welcome to the Forum sog481v I believe only option you have is to purchace the HC mag which holds 13rds It will work just stick out an inch or two from the bottom of the grip
  5. Replies
    4
    Views
    2,171

    Hey Deltone I had the same troulbe with my BT380...

    Hey Deltone I had the same troulbe with my BT380 when first purchased 5yrs ago I didnt no about forum and tried to figure things out myself It took almost 300rds. of ball ammo before It finally broke...
  6. Replies
    6
    Views
    1,489

    The slide is nickel plating over steel Hoppes #9...

    The slide is nickel plating over steel Hoppes #9 might react with the copper under the nickel plating any 2in1 cleaning lubricating oil you choose should be fine I have two guns with nickel slides...
  7. Replies
    6
    Views
    1,489

    I believe it is nickel plated on a steel slide...

    I believe it is nickel plated on a steel slide whoee I have them on my 40HC and BT380 they look brand new still just refrain from using Hoppes No. 9 to wipe down your nickel platted slide or parts it...
  8. Thread: Pro Mag?

    by Lefty
    Replies
    7
    Views
    1,334

    thrower as stated above It is wise to use factory...

    thrower as stated above It is wise to use factory mags especially in carry situations But as for your question about ProMag 9mm mags I use them with my 9HC at the range all the time with no problems...
  9. Thread: BP CC 9mm

    by Lefty
    Replies
    37
    Views
    6,778

    Welcome to the forum whoee Ive not heard of any...

    Welcome to the forum whoee Ive not heard of any yet making it to any gun dealers but the AC Amigo is starting to hit the gun shelves so maybe their presence will follow suit I`d like to check them...
  10. I dont believe to many compact firearms come with...

    I dont believe to many compact firearms come with adjustable rear sights normally intended for 1911's or compitition pistols with barrels 5" or longer thats probably why you cant find one. I dont...
  11. Thread: 380 CC Slide

    by Lefty
    Replies
    3
    Views
    1,832

    I think the barrel on the CC is 3.2" and regular...

    I think the barrel on the CC is 3.2" and regular 380 is 3.5" sorry lhtch I have the same problem with my BT380 thats why I purchased the fullsize 40HC Good Luck! Welcome to the forum!
  12. I would shoot from a sturdy rest at 25ft. then...

    I would shoot from a sturdy rest at 25ft. then put the laser on that point of impact then repeat same shot. should be pretty close then. Good Luck mspph!
  13. Thread: My bersa`s

    by Lefty
    Replies
    2
    Views
    2,104

    Marschalgrips.com Murdoch they do excellent work...

    Marschalgrips.com Murdoch they do excellent work the only problem is the 8 to 12 week waiting period till you recieve them. Hungary is where theyre located. Ordered some for my 40 also. Good Luck!
  14. If your serial no. is later than #80077 than...

    If your serial no. is later than #80077 than their interchangable with the Sig sights front sight #6 rear sight #8 TruGlo has them I believe dont know the cost though. Good Luck!
  15. Replies
    1
    Views
    942

    I believe Crimsom Trace has the only grip laser...

    I believe Crimsom Trace has the only grip laser combination but without fingercuts. you could try a hogue grip sleeve with that and trim where needed just a suggestion.
  16. Thread: My bersa`s

    by Lefty
    Replies
    2
    Views
    2,104

    My bersa`s

    Lefty`s three Bersa`s 9HC,40HC and 380
  17. Replies
    7
    Views
    1,209

    Probably try to call them first, Im sure they...

    Probably try to call them first, Im sure they sell worldwide warrenty should be the same and shipping will be on them if a problem presents itself.
  18. Replies
    7
    Views
    1,209

    I dont think the TFOs expire they just work...

    I dont think the TFOs expire they just work themselfs loose after numerous rds. The tritium can last up to 12yrs. well worth the money if you ask me. Truglo will take care of any problems you might...
  19. Replies
    7
    Views
    1,209

    Tritum nightsights not TFO`s fit the SigP220 rear...

    Tritum nightsights not TFO`s fit the SigP220 rear sight#8 front sight#6 I have pictures of them installed in this same section Nightsights for 9,40and45 I did want the TFO tritium style but heard...
  20. Replies
    7
    Views
    1,209

    I installed a set of TruGlo`s on my BT40HC using...

    I installed a set of TruGlo`s on my BT40HC using a vise a couple metal files it saved me $30. Had gunsmith install the first time and the front sight failed after 50rds. He used a punch to install...
  21. Have you taken them off before the cam srcew at...

    Have you taken them off before the cam srcew at the bottom needs to flush with the grip bottom to lock in. Ive taken mine off dozens of times sometimes the cam gets a little stubborn just wiggle the...
  22. No their not adjustalbe. They have no overhang...

    No their not adjustalbe. They have no overhang the rear one just slide right in, and secured it with the set screw provided the front filed bothe dovetail sides and the bottom just enough for a snug...
  23. Thread: New Bersa UC 45

    by Lefty
    Replies
    20
    Views
    3,175

    Nightsights for your 45UC

    Mepros and TruGlos will fit your gun just make you order it with the right size sight. The rear sight is #8 and the front sight is a #6 same as the SigP220. Ive posted pictures of the TruGlo tritium...
  24. Night sights

    Heres a picture of my BT40HC with TruGlo tritium night sights
  25. Hey Intercooler just checked out your sights you...

    Hey Intercooler just checked out your sights you got. Those are fiber optic, great for day not so much for low light conditions. Meprolite, Truglo are Tritium filled they glow 24/7 for twelve years...
Results 1 to 25 of 39
Page 1 of 2 1 2